A water cutting table is used as the substructure or surface for cutting gantries in the area of plasma torch cutting, water jet cutting as well as for combined water jet-plasma cutting. Its field of application is also in cutting processes that do not involve metalworking, such as sawing plants for stone.
• Corrugated grate under the cutting supports prevents small flame-cut parts getting into the tank
• Dispensing with suction extraction so lower energy requirements
• No dust pollution
• No manual cleaning required
• Longer service lives of the cutting support
Mode of function
The water level in this table system can be controlled fully automatically if required using internal air tanks. An integrated scraper outfeed transports cut parts and abrasive out at the front of the cutting table completely by means of a riser section during the cutting process. Deposits on the base of the pan are prevented by this self-cleaning system.
Optionally, a mechanical lifting device makes it possible to lift and lower two cutting supports automatically, separately from one another. While the cutting process is taking place on one support, the material can be unloaded and loaded on the other support. Logistics such as this in the cutting process reduce the preparation and follow-up times.
In addition, an intermittent function and night time setting are available so as to automate and optimise the conveying process.
For further information about special machine building, please refer to our brochure or contact us in person. You can use the following contact possibilities for this. We look forward to presenting you with our offer.
Brochure - special machines